Gravity: Analog Turbidity Sensor 水濁度感測器 水質檢測 養殖環境監測 For Arduino DFRobot原廠
NT$648 NT$500 未稅
濁度感測器利用光學原理,通過測量溶液中的透光率和散射率來綜合判斷溶液濁度情況,從而達到檢測水質的目的。
尚有庫存
- 商品說明
商品說明
Gravity: Analog Turbidity Sensor For Arduino 水濁度感測器 水質 養殖環境監測
濁度感測器利用光學原理,通過測量溶液中的透光率和散射率來綜合判斷溶液濁度情況,從而達到檢測水質的目的。
感測器內部是一個紅外線對管,當光線穿過一定量的水時,光線的透過量取決於該水的污濁程度,水越污濁,透過的光就越少。
感測器可以用於洗衣機、洗碗機,魚缸等產品的水污濁程度的測量。通過測量水的污濁程度來判斷溶液的潔淨程度,確定換水時間,達到減少能耗和節約用水的目的。也可以用於河流,污水的測量,澄清池檢測和水質研究等等。
感測器提供類比信號和數位信號兩種輸出模式。相容Gravity 3-Pin介面,可直連Arduino擴展版,免除二次接線的麻煩,簡單實用。
注意:感測器探頭頂端不防水,請勿浸沒使用,切記!
規格
- 工作電壓:5VDC
- 工作電流:40mA (MAX)
- 回應時間:<500ms
- 絕緣電阻:100MΩ (Min)
- 模擬量輸出:0-4.5V
- 數位量輸出:高/低電平信號(可以通過調節電位器選擇對應閾值)
- 操作溫度:-30℃~80℃
- 存儲溫度:-10℃~80℃
- 重量:30g
- 轉接板尺寸:38mm*28mm*10mm
接線圖
出貨清單
- Turbidity sensor adapter x1
- Turbidity sensor probe x1
- Turbidity sensor cable x1
- Gravity analog sensor cable x1
Documents
=========================================================
Gravity: Analog Turbidity Sensor For Arduino
The arduino turbidity sensor detects water quality by measuring level of turbidity. It is able to detect suspended particles in water by measuring the light transmittance and scattering rate which changes with the amount of total suspended solids (TSS) in water. As the TTS increases, the liquid turbidity level increases. You may also check Liquid Sensor Selection Guide to get better familar with our liquid sensor series.
This arduino turbidity sensor have both analog and digital signal output modes. You can select the mode according to the MCU as threshold is adjustable in digital signal mode.
Turbidity sensors can be used in measurement of water quality in rivers and streams, wastewater and effluent measurements, sediment transport research and laboratory measurements.
SPECIFICATION
- Operating Voltage: 5V DC
- Operating Current: 40mA (MAX)
- Response Time: <500ms
- Insulation Resistance: 100M (Min)
- Output Method:Analog
- Analog output: 0-4.5V
- Digital Output: High/Low level signal (you can adjust the threshold value by adjusting the potentiometer)
- Operating Temperature: 5℃~90 ℃
- Storage Temperature: -10℃~90℃
- Weight: 30g
- Adapter Dimensions: 38mm*28mm*10mm/1.5inches *1.1inches*0.4inches
DOCUMENTS
SHIPPING LIST
- Turbidity sensor adapter x1
- Turbidity sensor probe x1
- Turbidity sensor cable x1
- Gravity analog sensor cable x1
相關商品
-
5路循跡感測器 五路紅外線尋跡感測器 帶碰撞、距離檢測功能
0 滿分 5 分NT$190NT$152 未稅加入購物車Quick View -
加入購物車Quick View
TXB0104 電壓位準 I/O轉換板 4bit SparkFun原廠
0 滿分 5 分Texas Instruments TXB0104 模組的擴展板。TXB0104是一款具有自動方向感應功能的4位雙向電壓電平轉換器。這個4位非反相轉換器使用兩個獨立的可配置電源軌。A端口旨在跟踪VCCA。VCCA接受1.2V至3.6V的任何電源電壓。B端口用於跟踪VCCB。VCCB接受1.65V至5.5V的任何電源電壓。這允許在1.2V,1.5V,1.8V,2.5V,3.3V和5V電壓節點之間進行通用的低壓雙向轉換。VCCA不應超過VCCB。我們已經打破了這個模塊上的每個引腳,您可以輕鬆訪問A和B端口。
加入購物車Quick View -
Grove – Relay 繼電器模組 ( 峰值電壓能力250V 10安培) 支援 Arduino 與 Raspberry Pi seeed原廠
0 滿分 5 分繼電器是數位電路常用的控制開關元件,可用於控制更高的電壓和電流。設置為高電位時,指示燈會亮,繼電器ON。
NT$143NT$120 未稅加入購物車Quick View -
Grove – 3-Axis Analog Accelerometer 3軸加速度計 seeed原廠
0 滿分 5 分ADXL335 是一款小巧,薄型,低功耗,完整的3軸加速度計,具有信號調理電壓輸出。 該產品可測量加速度,最小滿量程範圍為±3 g。
NT$476NT$380 未稅加入購物車Quick View -
加入購物車Quick View
Grove – Multichannel Gas Sensor v2 多通道有害氣體感測器 seeed原廠
0 滿分 5 分加入購物車Quick View -
Fermion:LWLP5000 差壓感測器±500pa DFRobot原廠
0 滿分 5 分NT$1,524NT$1,420 未稅加入購物車Quick View -
Analog pH Meter Pro Sensor 模擬檢測 PH值(專業版) 相容Arduino DFRobot原廠
0 滿分 5 分NT$2,667NT$2,460 未稅加入購物車Quick View -
加入購物車Quick View
Grove – Rotary Angle Sensor 旋轉角度電位器模組 seeed原廠
0 滿分 5 分加入購物車Quick View -
ESP8266 串口 WIFI模組 遠距離 無線模組 ESP-07
0 滿分 5 分半孔貼片工藝,所有IO引出,帶金屬屏蔽殼,可過FCC CE認證,可外接IPX天線,也可用內置陶瓷天線
NT$143NT$100 未稅加入購物車Quick View -
Fermion: BMM150 Triple Axis Magnetometer Sensor 三軸數位地磁感測器 DFRobot原廠
0 滿分 5 分NT$286NT$260 未稅加入購物車Quick View