-
Battery Shield For WeMos D1 mini 單節鋰電池充電 電池升壓屏蔽
Battery Shield V1.1.0 For WeMos D1 mini 單節鋰電池充電和電池升壓屏蔽
Battery Shield V1.1.0 For WeMos D1 mini & D1 mini pro single lithium battery charging & boost
搭配本擴展板, 您可以將 D1 mini 放在任何地方,使用此電池升壓+ 18650 單節鋰電池或103450鋰電池擴展模組
- 18650103450 為 3.3v 而 D1 mini pro 需要 5V, 本擴展板具備升壓功能,只需將鋰電池連接到該屏蔽層,為整個D1迷你係統提供電源。
- 充電時,當電池電量耗盡時,您不需要拔掉電池,只需使用usb端口進行充電。
-
WEMOS D1 R2 V2.1 開發板 基於ESP8266 WEMOS Electronics 原廠出貨
WEMOS原廠2021年後生產的機板上不再有印刷WEMOS字樣,僅晶片鐵殼保留WeMos印刷字樣。
- 1 piece – Wemos D1 R2 Version 2.1 ESP8266 Development Board
- More than enough straight male header pins to solder into all of the open through-holes on the board
NT$352NT$300 未稅 -
Micro SD Shield for D1 mini wifi 記憶卡擴展底板
-
Dual Base for wemos mini D1 pro 擴展底板
NT$60 未稅 -
Wemos D1 Pro mini-16m 基於 ESP-8266EX 的迷你WiFi 開發板
- 1個數字輸入/輸出引腳
- Interrupt 中斷/ PWM / I2C /one-wire
- 1路模擬輸入(3.2V最大輸入)
- 16M bit Flash
- 外部天線連接器
- 內置陶瓷天線
- 新型CP2104 USB-TO-UART IC
-
Adafruit美國製 FT232H Breakout 模組 – General Purpose USB to GPIO+SPI+I2C
NT$500 – NT$520 未稅 -
NUCLEO-F103RB STM32F103RB 128K Mbed 開發板 原裝意法半導體進口 Arduino 相容腳座
NUCLEO-F103RB STM32F103RB 128K Mbed 開發板 原裝意法半導體進口 Arduino 相容腳座
STM32 Nucleo-64開發板採用 STM32F103RB MCU,支持Arduino和ST形態連接。STM32 Nucleo板為用戶提供了一種經濟實惠且靈活的方式,可以從STM32微控制器中嘗試新的概念並構建原型,從性能,功耗和功能的各種組合中進行選擇。Arduino™Uno V3連接支持和ST morpho頭部允許輕鬆擴展STM32 Nucleo開放平台的功能
-
NUCLEO-F411RE STM32F411RE Mbed 開發板 原裝意法半導體進口 Arduino 相容腳座
NUCLEO-F411RE STM32F411RE Mbed 開發板 原裝意法半導體進口 Arduino 相容腳座
STM32 Nucleo-64開發板採用STM32F411RE MCU,支持Arduino和ST形態連接。STM32 Nucleo板為用戶提供了一種經濟實惠且靈活的方式,可以從STM32微控制器中嘗試新的概念並構建原型,從性能,功耗和功能的各種組合中進行選擇。Arduino™Uno V3連接支持和ST morpho頭部允許輕鬆擴展STM32 Nucleo開放平台的功能
-
NUCLEO-F446RE STM32F446RE Mbed 開發板 原裝意法半導體進口
NT$800 未稅 -
Adafruit美國製 HUZZAH ESP8266 Breakout
Adafruit HUZZAH ESP8266 Breakout
Add Internet to your next project with an adorable, bite-sized WiFi microcontroller, at a price you like! The ESP8266 processor from Espressif is an 80 MHz microcontroller with a full WiFi front-end (both as client and access point) and TCP/IP stack with DNS support as well. While this chip has been very popular, its also been very difficult to use. Most of the low cost modules are not breadboard friendly, don’t have an onboard 500mA 3.3V regulator or level shifting, and aren’t CE or FCC emitter certified….UNTIL NOW!
NT$457NT$440 未稅