





DS18B20 測溫傳感器 模組 for For WeMos D1 mini 溫度感測器模組
NT$80 未稅
DS18B20 測溫傳感器模組 for For WeMos D1 mini 溫度感測器模組
尚有庫存
- 商品說明
商品說明
DS18B20 測溫傳感器 模組 for For WeMos D1 mini 溫度感測器模組
DS18B20 測溫傳感器 產品特點:
- 配套D1 MINI使用
- Arduino 兼容,使用Arduino IDE進行編程
- 11XI/O引腳
- 1XADC引腳(輸入0-3.3V)
- 支持OTA上線
發貨清單(靜電袋包裝):
1.長型排母X2PCS
2.短型排母X2PCS
3.普通排針X2PCS
4.DS18B20測溫模塊(FOR D1-MINI)X1PCS
DS18B20 測溫傳感器
引腳定義(DS18B20測溫模塊VCC與GND連接D1 MINI主板,佔用數據IO口為D2):
The DS18B20 digital thermometer provides 9-bit to 12-bit Celsius temperature measurements and has an alarm function with nonvolatile user-programmable upper and lower trigger points. The DS18B20 communicates over a 1-Wire bus that by definition requires only one data line (and ground) for communication with a central micro-processor. In addition, the DS18B20 can derive power directly from the data line (?parasite power?), eliminating the need for an external power supply.
Each DS18B20 has a unique 64-bit serial code, which allows multiple DS18B20s to function on the same 1-Wire bus. Thus, it is simple to use one microprocessor to control many DS18B20s distributed over a large area. Applications that can benefit from this feature include HVAC environmental controls, temperature monitoring systems inside buildings, equipment, or machinery, and process monitoring and control systems.
Features
-
- Unique 1-Wire® Interface Requires Only One Port Pin for Communication
- Reduce Component Count with Integrated Temperature Sensor and EEPROM
- Measures Temperatures from -55°C to +125°C (-67°F to +257°F)
- ±0.5°C Accuracy from -10°C to +85°C
- Programmable Resolution from 9 Bits to 12 Bits
- No External Components Required
- Parasitic Power Mode Requires Only 2 Pins for Operation (DQ and GND)
- Simplifies Distributed Temperature-Sensing Applications with Multidrop Capability
- Each Device Has a Unique 64-Bit Serial Code Stored in On-Board ROM
- Flexible User-Definable Nonvolatile (NV) Alarm Settings with Alarm Search Command Identifies Devices with Temperatures Outside Programmed Limits
Lieferumfang
1x WeMos DS18B20 Shield für D1 mini
2x Stiftleiste kurz
2x Buchsenleiste kurz
2x Buchsenleiste lang
相關商品
-
DHT Shield for D1 mini DHT11 Singlebus 數字溫濕度感測器擴展模組
0 滿分 5 分DHT Shield for WeMos D1 mini DHT11 Single-bus 數字溫濕度感測器擴展模組
DHT Shield for WeMos D1 mini DHT11 Single-bus digital temperature and humidity sensor module sensor
-
Weather Shield 天氣感測擴展板 Sparkfun美國製
0 滿分 5 分SparkFun Weather Shield是一款易於使用的 Arduino 擴展板,可讓您獲得氣壓,相對濕度,亮度和溫度。
NT$1,714NT$1,380 未稅 -
Micro SD Shield for D1 mini wifi 記憶卡擴展底板
0 滿分 5 分 -
DS18B20 單匯流排數位溫度感測器模組
0 滿分 5 分DS18B20 單匯流排數位溫度感測器模組
一、長尺寸:28mm X寬12mm X高10mm
二、主要芯片:18B20溫度傳感器
三、工作電壓:直流5VNT$86NT$60 未稅 -
WeMos D1 Mini Pro wifi 開發板14件模組學習套件 基於 ESP8266 NodeMcu Lua
0 滿分 5 分購買後請來信索取相關範例資料
NT$1,190NT$940 未稅 -
LOLIN (WeMos) D1 WiFi Arduino UNO 開發板ESP8266 ESP-12F 直接用 Arduino IDE 開發
0 滿分 5 分WeMos D1 WiFi Arduino UNO 開發板 物聯網應用開發板
- 微控制器:ESP-8266EX
- WIFI頻率:2.4GHz
- IEEE 802.11 b / g / n
- WiFi功率放大器(PA):+25dBm
- 輸入介面:Micro USB
- 工作電壓:3.3V
- 時脈:80 / 160 MHz
- 數位I/O PIN:11支接腳
- 類比輸入PIN:1支接腳
- FLASH:4MB
- DC O2.1mm插孔
- Arduino兼容,使用Arduino IDE來編程,
- 支援OTA無線上傳
- 板載5V 1A開關電源 (最高輸入電壓24V)
- 安裝後,直接用Arduino IDE 開發,跟Arduino UNO 一樣操作
NT$286NT$200 未稅 -
WeMos D1 ESP-Wroom-02 開發板 ESP8266主板內建18650電池座
0 滿分 5 分當你做一些 ESP8266 開發時若要使用行動電源運作會覺得很困擾,而這個微型板可以解決這樣的問題。 3000mah 18650電池可以使該ESP8266模組運行17小時。
NT$381NT$240 未稅 -
DS18b20 溫度感測器 防水探針型熱電偶溫度感測器 不銹鋼封裝 長度3000cm 30米
0 滿分 5 分DS18b20溫度感測器包括一個金屬探測器和 3000cm(30米) 的電纜,具有較寬的溫度測量範圍 (-55 ° C 到 125 ° C ),適合沉浸式溫度檢測。注意事項: 電纜線部分不能承受溫度高於 105 ° c
優質不銹鋼管封裝 防水防潮防生鏽,探頭採用原装DS18B20溫度傳感器晶片,每個引腳均用熱縮管隔開,防止短路,內部封膠,防水防潮,優質不銹鋼管封裝防生鏽
不銹鋼外殼(6*50mm),引線長度 3000cm
3.0V~5.5V供電
9~12位可調分辨率
感溫範圍寬-55℃ ~ +125℃
輸出引線:紅色(VCC),藍(黃)色(DATA),黑色(GND)
NT$667NT$620 未稅 -
Relay Shield V2 for WEMOS D1 mini 一路5V繼電器模組
0 滿分 5 分NT$67NT$60 未稅 -
Wemos D1 Pro mini-16m 基於 ESP-8266EX 的迷你WiFi 開發板
0 滿分 5 分- 1個數字輸入/輸出引腳
- Interrupt 中斷/ PWM / I2C /one-wire
- 1路模擬輸入(3.2V最大輸入)
- 16M bit Flash
- 外部天線連接器
- 內置陶瓷天線
- 新型CP2104 USB-TO-UART IC