Analog/Digital MUX Breakout – CD74HC4067 高速CMOS 16通道類比數位訊號多工器
NT$124 NT$105 未稅
CD74HC4067 高速CMOS 16通道 類比數位訊號 多工器 Analog/Digital 使用一路ADC 採集16路模擬信號
This is a breakout board for the very handy 16-Channel Analog/Digital Multiplexer/Demultiplexer CD74HC4067. This chip is like a rotary switch – it internally routes the common pin (COM in the schematic, SIG on the board) to one of 16 channel pins (CHANxx). It works with both digital and analog signals (the voltage can’t be higher than VCC), and the connections function in either direction. To control it, connect 4 digital outputs to the chip’s address select pins (S0-S3), and send it the binary address of the channel you want (see the datasheet for details). This allows you to connect up to 16 sensors to your system using only 5 pins!
尚有庫存
- 商品說明
商品說明
CD74HC4067 高速 CMOS 16通道 類比數位訊號 多工器 Analog/Digital 使用一路ADC 採集16路模擬信號
CD74HC4067 是非常方便的16通道模擬/數字多路復用器/多路解復用器CD74HC4067的分線板。該芯片就像一個旋轉開關 – 它在內部將公共引腳(原理圖中的COM,電路板上的SIG)路由到16個通道引腳(CHANxx)之一。它適用於數字和模擬信號(電壓不能高於VCC),並且連接在任一方向上起作用。要控制它,將4個數字輸出連接到芯片的地址選擇引腳(S0-S3),並將其發送到所需通道的二進制地址(有關詳細信息,請參見數據表)。這允許您僅使用5個引腳將最多16個傳感器連接到您的系統!
由於mux / demux也可以處理數字信號,因此您可以使用它將TTL級串行數據傳輸到多個設備或從多個設備傳輸。例如,您可以使用它將16個器件的TX引腳連接到微控制器上的一個RX引腳。然後,您可以選擇要監聽的16個設備中的任何一個。如果您需要雙向通信,可以添加第二塊電路板,將微控制器的TX線路連接到16個設備的RX線路。通過使用多個板,您可以為I2C,SPI等創建類似的安排。
內部開關是雙向的,支持地和VCC之間的電壓,具有低“導通”電阻和低“關斷”洩漏,並且為了防止串擾,執行“先斷後合”切換。電路板還會斷開芯片的“使能”引腳,當驅動為高電平時,該引腳將完全斷開公共引腳(所有開關“關閉”)。
特徵
- 2V至6V操作
- “開”電阻:70歐姆@ 4.5V
- 6ns先斷後續@ 4.5V
- 寬工作溫度範圍:-55C至125C
=========================================================
CD74HC4067 16-Channel Analog Digital Multiplexer Breakout Board Module Arduino
This is a breakout board for the very handy 16-Channel Analog/Digital Multiplexer/Demultiplexer CD74HC4067. This chip is like a rotary switch – it internally routes the common pin (COM in the schematic, SIG on the board) to one of 16 channel pins (CHANxx). It works with both digital and analog signals (the voltage can’t be higher than VCC), and the connections function in either direction. To control it, connect 4 digital outputs to the chip’s address select pins (S0-S3), and send it the binary address of the channel you want (see the datasheet for details). This allows you to connect up to 16 sensors to your system using only 5 pins!
Since the mux/demux also works with digital signals, you can use it to pipe TTL-level serial data to or from multiple devices. For example, you could use it to connect the TX pins of 16 devices to one RX pin on your microcontroller. You can then select any one of those 16 devices to listen to. If you want two-way communications, you can add a second board to route your microcontroller’s TX line to 16 device’s RX lines. By using multiple boards, you can create similar arrangements for I2C, SPI, etc.
The internal switches are bidirectional, support voltages between ground and VCC, have low “on” resistance and low “off” leakage, and to prevent crosstalk, perform “break-before-make” switching. The board also breaks out the chip’s “enable” pin, which when driven high, will completely disconnect the common pin (all switches “off”).
Features
- 2V to 6V operation
- “On” resistance: 70 Ohms @ 4.5V
- 6ns break-before-make @ 4.5V
- Wide operating temperature range: -55C to 125C
Documents
相關商品
-
炫光型電容式觸摸感測器模組
0 滿分 5 分炫光型電容式觸摸感測器模組
在便攜式媒體播放器和移動手持終端等大容量、高可視性產品的應用中,觸摸按鍵已被廣泛採用。由於其具有方便易用,時尚和低成本的優勢,越來越多的電子產品開始從傳統機械按鍵轉向觸摸式按鍵。
加入購物車Quick View -
RFID RC522 鑰匙扣卡 13.56MHz 相容 Philip Mifare S50 非接觸式 (10個一組)
0 滿分 5 分RFID 13.56MHz RC522 鑰匙扣卡 相容 Philip Mifare S50 非接觸式 (10個一組)
由ABS外殼封裝芯片線圈並填充環氧樹脂,通過超聲波焊接組合的具有各種造型的異形卡。應用範圍:水錶預付費,校園一卡通、公交儲值卡、高速公路收費、停車場、小區管理
- IC鑰匙扣卡頻率: 13.56MHZ
- IC鑰匙扣卡規格: 28*35.3*4MM IC鑰匙
NT$129NT$86 未稅加入購物車Quick View -
TXS0108E 8路電平轉換模組 高速全雙工 8位元雙向電壓轉換器
0 滿分 5 分NT$114NT$86 未稅加入購物車Quick View -
Grove – Recorder v3.0 錄音感測器 錄音機 語音錄放模組 seeed原廠
0 滿分 5 分NT$733NT$560 未稅加入購物車Quick View -
加入購物車Quick View
Grove – Button按鈕控制器 支援Arduino與樹莓派 seeed原廠
0 滿分 5 分加入購物車Quick View -
Grove-Magnetic Switch 磁力開關模組 seeed原廠
0 滿分 5 分NT$114NT$100 未稅加入購物車Quick View -
新款PL2303TA USB轉串口模组傳輸線 USB轉 TTL/RS232 支持WIN7
0 滿分 5 分注意!WIN8/WIN10 不支援!
NT$190NT$80 未稅加入購物車Quick View -
JoyStick 雙軸按鍵搖杆模組
0 滿分 5 分PS2雙軸按鍵遊戲搖桿模塊採用SONY公司PS2遊戲手柄上原裝優質金屬按鍵搖桿電位器,模塊特設二路模擬輸出和一路數字輸出接口,輸出值分別對應(X,Y)雙軸偏移量,其類型為模擬量;按鍵表示用戶是否在Z軸上按下,其類型為數字開關量。模塊集成電源指示燈,可顯示工作狀態;坐標標識符清晰簡明、準確定位;用其可以輕鬆控制物體(如二自由度舵機雲台)在二維空間運動,因此可以通過Arduino控制器編程,傳感器擴展板插接,完成具有創意性遙控互動作品
NT$62NT$20 未稅加入購物車Quick View -
360度 旋轉編碼器模組 支援Arduino
0 滿分 5 分增量編碼器是一種將旋轉位移轉換為一連串數字脈衝信號的旋轉式傳感器。這些脈衝用來控制角位移。在 Eltra 編碼器中角位移的轉換採用了光電掃描原理。讀數係統以由交替的透光窗口和不透光窗口構成的徑向分度盤(碼盤)的旋轉為依據,同時被一個紅外光源垂直照射,光把碼盤的圖像投射到接收器表面上。接收器覆蓋著一層衍射光柵,它具有和碼盤相同的窗口寬度。接收器的工作是感受光盤轉動所產生的變化,然後將光變化轉換成相應的電變化。再使低電平信號上升到較高電平,並產生沒有任何干擾的方形脈衝,這就必須用電子電路來處理。讀數係統通常採用差分方式,即將兩個波形一樣但相位差為 180 °的不同信號進行比較,以便提高輸出信號的質量和穩定性。讀數是再兩個信號的差別基礎上形成的,從而消除了乾擾。
NT$62NT$43 未稅加入購物車Quick View -
微動開關 TACK-SW 4P 6x6x5mm(H) 10個一包
0 滿分 5 分微動開關 TACK-SW 10P 一包
尺寸:6mm x 6mm x 5.0mmNT$29NT$24 未稅加入購物車Quick View