MPL3115A2 高度壓力感測器模組 Altitude/Pressure Sensor Breakout SparkFun原廠
NT$580 未稅
MPL3115A2 是一個MEMS壓力傳感器,可將海拔數據提供到30厘米以內(採用過採樣)。
尚有庫存
- 商品說明
商品說明
MPL3115A2 高度壓力感測器模組 Altitude/Pressure Sensor Breakout
MPL3115A2 是一個MEMS壓力傳感器,可將海拔數據提供到30厘米以內(採用過採樣)。傳感器輸出由高分辨率24位ADC數字化,並通過I2C傳輸,這意味著與大多數控制器的接口很容易。壓力輸出可以通過Pascal分數的輸出來解決,海拔高度可以以分米計算。該器件還以攝氏度提供12位溫度測量。
特徵
- 1.95V至3.6V電源電壓,由LDO內部調節
- 1.6V至3.6V數字接口電源電壓
- 內部全面補償
- 直接閱讀,補償
- 壓力:20位測量(帕斯卡)
- 海拔高度:20位測量(米)
- 溫度:12位測量(攝氏度)
- 可編程事件
- 自主數據採集
- 分辨率低至1英尺/ 30厘米
- 32採樣FIFO
- 使用FIFO記錄數據最多12天的能力
- 1秒至9小時數據採集率
- I2C數字輸出接口(工作頻率高達400 kHz)
Documents
=========================================================
SparkFun Altitude/Pressure Sensor Breakout – MPL3115A2
Life has its ups and downs, so why not measure them? The MPL3115A2 is a MEMS pressure sensor that provides Altitude data to within 30cm (with oversampling enabled). The sensor outputs are digitized by a high resolution 24-bit ADC and transmitted over I2C, meaning it’s easy to interface with most controllers. Pressure output can be resolved with output in fractions of a Pascal, and Altitude can be resolved in fractions of a meter. The device also provides 12-bit temperature measurements in degrees Celsius.
This breakout board makes it easy to prototype using this tiny device by breaking out the necessary pins to a standard 0.1″ spaced header. The board also has all of the passive components needed to get the device functioning, so you can simply connect it to something that talks I2C and get to work!
Features:
- 1.95V to 3.6V Supply Voltage, internally regulated by LDO
- 1.6V to 3.6V Digital Interface Supply Voltage
- Fully Compensated internally
- Direct Reading, Compensated
- Pressure: 20-bit measurement (Pascals)
- Altitude: 20-bit measurement (meters)
- Temperature: 12-bit measurement (degrees Celsius)
- Programmable Events
- Autonomous Data Acquisition
- Resolution down to 1 ft. / 30 cm
- 32 Sample FIFO
- Ability to log data up to 12 days using the FIFO
- 1 second to 9 hour data acquisition rate
- I2C digital output interface (operates up to 400 kHz)
Documents:
- Schematic
- Eagle Files
- Hookup Guide
- Datasheet (MPL3115A2)
- GitHub (Design Files & Example Code)
- GitHub (Library)
- Product Video
相關商品
-
加入購物車Quick View
Grove – Multichannel Gas Sensor v2 多通道有害氣體感測器 seeed原廠
0 滿分 5 分加入購物車Quick View -
TF Mini LiDAR 12m (ToF) 雷射 激光 距離測量傳感器/感測器 DFRobot原廠
0 滿分 5 分TF Mini LiDAR是一款基於飛行時間(ToF)技術的單向激光測距儀。
它由特殊的光學和電子設備組成,集成了適用於室內和室外應用環境的自適應算法。
它具有纖巧的機身和遠距離測量的高性能。
NT$1,600NT$1,420 未稅加入購物車Quick View -
Fermion: BMM150 Triple Axis Magnetometer Sensor 三軸數位地磁感測器 DFRobot原廠
0 滿分 5 分NT$286NT$260 未稅加入購物車Quick View -
Analog pH Meter Pro Sensor 模擬檢測 PH值(專業版) 相容Arduino DFRobot原廠
0 滿分 5 分NT$2,667NT$2,460 未稅加入購物車Quick View -
加入購物車Quick View
HC-05 串口藍牙模組 (帶底板) 主機/從機可設定 / 帶底板,附 Arduino 範例
0 滿分 5 分請勿將電源接到信號腳上,會直接燒壞模組!
藍牙透傳模組只有4個AT指令,分別是測試通訊,改名稱,改串列傳輸速率,改配對密碼,AT指令必須從TXD,RXD信號腳設置,不能通過藍牙通道設置。發送AT指令的設備可以是各種類型的MCU(比如51,avr,pic,msp430,arm等),也可以是電腦通過串口(PC串口接MAX232以後或者USB轉串口)發送。
加入購物車Quick View -
加入購物車Quick View
Force Sensitive Resistor – FSR400 Small 電阻式壓力感測器 SparkFun原廠
0 滿分 5 分直徑為0.16“(4 mm)的有源感應區域,Interlink Electronics的FSR會根據傳感區域的壓力而改變其阻力,力越強,電阻越小,當沒有壓力應用於FSR,其電阻將大於1MΩ,全壓施加電阻為2.5kΩ。
加入購物車Quick View -
加入購物車Quick View
單片機TTL轉RS485模組 485轉串口UART電平互轉 硬體自動控制流向
0 滿分 5 分加入購物車Quick View -
Grove – PIR Motion Sensor 紅外線人體移動探測感測器 seeed原廠
0 滿分 5 分這是一個極易使用的紅外線 PIR人體運動探測感測器。通過這個感測器,你可以使你的作品對運動,例如人類的運動作出互動。只要將其接到Grove – Base Shield上,並且下載程序,當有人走入它的探測範圍時,PIR運動探測傳感器就會在它的SIG腳上輸出一個HIGH信號。
NT$333NT$260 未稅加入購物車Quick View -
Grove – Infrared Temperature Sensor 紅外線 溫度感測器模組 seeed原廠
0 滿分 5 分紅外溫度傳感器通過接收物體發出的紅外線來測量其溫度。
NT$457NT$380 未稅加入購物車Quick View -
加入購物車Quick View
Grove – Rotary Angle Sensor 旋轉角度電位器模組 seeed原廠
0 滿分 5 分加入購物車Quick View