- 商品說明
商品說明
Infrared CO2 Sensor 0-50000ppm(Wide Range) 二氧化碳傳感器模塊
DFRobot最新推出高精度大量程紅外二氧化碳傳感器,有效量程可達0~50000ppm。該款傳感器是一個通用型、小型傳感器,利用非色散紅外(NDIR技術)原理對空氣中存在的CO2進行探測,具有很好的選擇性,無氧氣依賴性,使用壽命長達5年。並且內置溫度補償,使用串口,就可讀取當前CO2氣體濃度,使用非常簡單,兼容各類單片機和傳感器。
該紅外傳感器是將成熟的紅外吸收氣體檢測技術製作出的高性能傳感器。具有抗水汽干擾,不中毒,壽命長等特點,可以長時間放在空氣中使用,避免了中毒後長時間的加熱。可廣泛應用於智能農業,暖通製冷與室內空氣質量監控,工業過程及安全防護監控,農業及畜牧業生產過程監控等。
特徵
- 氣室採用鍍金處理,防水防腐蝕
- 高靈敏度、低功耗
- 優異的穩定性
- 溫度補償,卓越的線性輸出
- 使用壽命長
- 抗水汽干擾、不中毒
- 兼容3.3V和5V主控器(注意:使用3.3V設備時,仍然可以5V供電)
規格
- 檢測氣體: 二氧化碳
- 工作電壓: 4.5~5.5V DC
- 平均電流: < 85 mA
- 輸出信號: UART/PWM/Analog輸出(後面兩個接口未引出)
- 測量範圍: 0~50000ppm
- 精度:±(50ppm+5%讀數)
- 預熱時間: 3min
- 響應時間: T 90 < 30s
- 工作溫度: 0~50℃
- 工作濕度: 0~95%RH (無凝結)
- 壽命: >5 年
- 電路板尺寸:21mm*27.11mm
- 重量:42g
接線圖
出貨清單
- UART紅外CO2傳感器探頭(0-50000ppm)x1
- 傳感器轉換板 x1
- 6針傳感器電線 x1
- PH2.0重力UART電線 x1
- XH2.54 4針排針 x1
Documents
=========================================================
Gravity: UART Infrared CO2 Sensor (0-50000ppm)
DFRobot released its latest wide range Arduino infrared CO2 sensor, which effective range is up to 0~50000ppm. This sensor is based on non-dispersive infrared (NDIR) technology and has good selectivity and oxygen-free dependency. It integrates temperature compensation and support UART communication mode. Most importantly, the product is easy to use; it is compatible with all types of microcontrollers with UART port, like Arduino, Raspberry Pi and other microcontrollers. Besides, it has a long service life, up to 5 years!
In addition, this UART Infrared CO2 Sensor is a high-performance sensor that combines technology of mature infrared absorption gas detection with precision optical circuit design as well as sophisticated circuit design. It has characteristics such as wide range detection, high sensitivity, high resolution, low power consumption, fast response, anti-water vapor interference, no poisoning, high stability and long life.
It can be widely used in HVAC refrigeration and indoor air quality monitoring, industrial process and safety monitoring, agricultural and animal husbandry production process monitoring, etc..
This is a 0~50000ppm wide range CO2 sensor with UART communication port. It supports Arduino, Raspberry Pi and other microcontrollers. In addition, we also have a 0~5000 ppm high precision infrared sensor with Gravity Analog interface, more easy to use: Gravity Analog Infrared CO2 Sensor (0~5000ppm).
FEATURES
- High sensitivity High resolution
- Low power consumption
- Excellent stability
- Temperature compensation
- Excellent linear output
- High cycle life
- Anti-water vapor interference
- No poisoning
- Need 5V power supply, even you are using a 3.3V microcontroller, like Genuino 101/ Raspberry Pi .etc.
SPECIFICATION
- Gas Detection: Carbon Dioxide (CO2)
- Operating Voltage: 4.5 ~ 5.5V DC
- Average Current: <85mA
- Output Signal: UART/PWM/Analog output (the last two has not been developed)
- Measuring Range: 0 ~ 50000ppm
- Accuracy: ± (50ppm + 5% reading)
- Preheating Time: 3min
- Response Time: T90 < 30s
- Operating Temperature: 0 ~ 50 ℃
- Operating Humidity: 0 ~ 95% RH (no condensation)
- Service Life: >5 years
- Board Dimension : 21 * 27.11 mm/ 0.83 * 1.06 inches
- Weight: 42g
DOCUMENTS
SHIPPING LIST
- UART Infrared CO2 Sensor Probe (0-50000ppm) x1
- Sensor Converter Board x1
- 6-Pin Sensor Cable x1
- PH2.0 Gravity UART Cable x1
- XH2.54 4-Pin header x1
相關商品
-
Grove – Alcohol Sensor 酒精感測器 seeed原廠
0 滿分 5 分酒精感測器(傳感器)為酒精專用檢測半導體傳感器。它具有良好的靈敏度和回應速度快的特性,本模組適用用於開發便攜式酒精檢測系統。
NT$286NT$220 未稅加入購物車Quick View -
Grove – Relay 繼電器模組 ( 峰值電壓能力250V 10安培) 支援 Arduino 與 Raspberry Pi seeed原廠
0 滿分 5 分繼電器是數位電路常用的控制開關元件,可用於控制更高的電壓和電流。設置為高電位時,指示燈會亮,繼電器ON。
NT$143NT$120 未稅加入購物車Quick View -
加入購物車Quick View
Force Sensitive Resistor – FSR400 Small 電阻式壓力感測器 SparkFun原廠
0 滿分 5 分直徑為0.16“(4 mm)的有源感應區域,Interlink Electronics的FSR會根據傳感區域的壓力而改變其阻力,力越強,電阻越小,當沒有壓力應用於FSR,其電阻將大於1MΩ,全壓施加電阻為2.5kΩ。
加入購物車Quick View -
FlexiForce 壓力感測器 – 1磅 SparkFun原廠
0 滿分 5 分
NT$781NT$740 未稅加入購物車Quick View -
電流轉電壓模組 0/4-20mA 轉 0-3.3V、5V、10V 電壓變送器 信號轉換調理
0 滿分 5 分在電路信號傳輸的過程中電壓信號會隨著傳輸距離的增加而變弱,採用電流傳輸可以避免信號的變弱。
本模組用於電流信號傳輸末端,將信號轉換成電壓信號供單片機檢測。
電流輸入支援4-20Ma、0-20mA,電壓輸出支援0-3.3V、0-5V、0-10V
NT$190NT$114 未稅加入購物車Quick View -
Gravity: Analog Turbidity Sensor 水濁度感測器 水質檢測 養殖環境監測 For Arduino DFRobot原廠
0 滿分 5 分濁度感測器利用光學原理,通過測量溶液中的透光率和散射率來綜合判斷溶液濁度情況,從而達到檢測水質的目的。
NT$648NT$500 未稅加入購物車Quick View -
加入購物車Quick View
單片機TTL轉RS485模組 485轉串口UART電平互轉 硬體自動控制流向
0 滿分 5 分加入購物車Quick View -
加入購物車Quick View
HC-05 串口藍牙模組 (帶底板) 主機/從機可設定 / 帶底板,附 Arduino 範例
0 滿分 5 分請勿將電源接到信號腳上,會直接燒壞模組!
藍牙透傳模組只有4個AT指令,分別是測試通訊,改名稱,改串列傳輸速率,改配對密碼,AT指令必須從TXD,RXD信號腳設置,不能通過藍牙通道設置。發送AT指令的設備可以是各種類型的MCU(比如51,avr,pic,msp430,arm等),也可以是電腦通過串口(PC串口接MAX232以後或者USB轉串口)發送。
加入購物車Quick View -
5路循跡感測器 五路紅外線尋跡感測器 帶碰撞、距離檢測功能
0 滿分 5 分NT$190NT$152 未稅加入購物車Quick View -
Grove – RTC 高精度時間模組 seeed原廠
0 滿分 5 分支持I2C協議的時鐘芯片DS1307。它使用鋰電池(CR1225)。時鐘/日曆提供秒,分,小時,日,日,月和年信息。
NT$271NT$220 未稅加入購物車Quick View