Gravity: Digital I2C Signal Isolator 數字I2C 信號隔離器 DFRobot原廠
NT$619 NT$560 未稅
數字信號隔離器能夠隔離I2C數字信號並為傳感器模塊提供隔離電源,有效防止傳感器模塊之間的相互干擾。該數字信號隔離器可用於多參數水質檢測系統,以防止水質傳感器相互干擾。
尚有庫存
- 商品說明
商品說明
Gravity: Digital I2C Signal Isolator 數字I2C 信號隔離器
Digital I2C Signal Isolator 數字信號隔離器能夠隔離I2C數字信號並為傳感器模塊提供隔離電源,有效防止傳感器模塊之間的相互干擾。該數字信號隔離器可用於多參數水質檢測系統,以防止水質傳感器相互干擾。
在許多情況下,存在干擾源。例如,魚缸中的運行泵將向水中釋放信號,這會干擾魚缸中的傳感器。在這種情況下,需要電隔離以確保傳感器的穩定操作。一些傳感器,如pH傳感器和電導率傳感器,在同一容器中共用相同的電源和測量值,會相互干擾,無法正常工作。為了確保傳感器模塊的穩定運行,必須隔離信號和電源。
在模擬信號隔離器之後,我們推出了這種數字信號隔離器,專門隔離I2C數字信號。此外,板載5V隔離電源芯片可直接為傳感器模塊供電,無需額外電源。本產品專為 DFRobot I2C 連接器傳感器或模塊而設計,即插即用,無需焊接。將其連接到電路中進行電氣隔離,控制板上的傳感器模塊代碼無需修改,簡單方便。
接口說明
- 1.Module端(隔離端)最大輸出電流不得超過150mA,請注意負載的工作電流!
- 2.Module端(隔離端)的所有管腳與Controller端(非隔離端)的所有管腳之間是相互隔離的,嚴禁將其短接!
- 3.工作過程中,隔離電源模塊會發熱,屬正常現象。
注意:
接線圖
特徵
- 板載5V 0.75W隔離電源芯片,無需額外電源,簡單方便
- 幾乎兼容所有DFRobot I2C連接器傳感器或模塊,即插即用,無需焊接
規格
- 工作電壓:5.0V
- 連接器類型:PH2.0-4P
- 接口協議:I2C(IIC)
- 接口信號電平:高3.3V,低0V
- 尺寸:42 * 32mm / 1.65 * 1.26英寸
控制器側(非隔離側)
- 電源電壓:5.0±0.15V
- 空載電流:15mA(TYP)
模塊側(隔離側)
- 輸出電壓:5.0±0.15V
- 輸出電流:150mA(MAX)
出貨清單
- 重力:數字I2C 信號隔離器 x1
- 雙PH2.0-4P電纜x1
- 重力-4P I2C / UART 傳感器電纜 x1
- XH2.54-4Pin x2
Documents
=========================================================
Gravity: Digital I2C Signal Isolator
Gravity: Digital Signal Isolator is capable of isolating I2C digital signal and providing isolated power to the sensor module, effectively preventing mutual interference between the sensor modules. This digital signal isolator can be used for multi-parameter water quality detection systems to prevent water quality sensors from interfering with each other.
In many cases, interference sources are existing. For example, a running pump in a fish tank will release signals into the water, which interferes the sensors in the fish tank. In this case, electrical isolation is needed to ensure the stable operation of the sensors. Some sensors, such as pH sensors and electrical conductivity sensors, which share the same power source and measure in the same container, will interfere with each other and do not work properly. In order to ensure stable operation of the sensor modules, it is necessary to isolate the signal and the power.
After the analog signal isolator, we launched this digital signal isolator which specifically isolates the I2C digital signal. What’s more, the on-board 5V isolation power chip can directly supply the sensor module, without additional power. This product is designed specifically for DFRobot I2C connector sensor or modules, plug and play, no welding. Connect it into your circuit to get electrical isolation, and the code of sensor module in control board does not need to be modified, which is simple and convenient.
Note:
2. All pins on the Module side (isolation side) are isolated from all pins on the Controller side (non-isolation side). Do not short-circuit them.
3. It is normal for the isolator generates heat while working.
FEATURES
- Onboard 5V 0.75W isolation power chip, no additional power needed, simple and convenient
- Almost compatible with all DFRobot I2C connector sensors or modules, plug and play, no welding
SPECIFICATION
- Operating Voltage: 5.0V
- Connector Type: PH2.0-4P
- Interface Protocol: I2C(IIC)
- Interface Signal Level: High 3.3V, Low 0V
- Dimension: 42 * 32mm / 1.65 * 1.26 inch
Controller Side(Non-isolation Side)
- Supply Voltage: 5.0 ± 0.15V
- No-load Current: 15mA(TYP)
Module Side(Isolation Side)
- Output Voltage: 5.0 ± 0.15V
- Output Current: 150mA(MAX)
DOCUMENTS
SHIPPING LIST
- Gravity: Digital I2C Signal Isolator x1
- Double PH2.0-4P Cable x1
- Gravity-4P I2C/ UART Sensor Cable x1
- XH2.54-4Pin Header x2
相關商品
-
Grove – PIR Motion Sensor 紅外線人體移動探測感測器 seeed原廠
0 滿分 5 分這是一個極易使用的紅外線 PIR人體運動探測感測器。通過這個感測器,你可以使你的作品對運動,例如人類的運動作出互動。只要將其接到Grove – Base Shield上,並且下載程序,當有人走入它的探測範圍時,PIR運動探測傳感器就會在它的SIG腳上輸出一個HIGH信號。
NT$333NT$260 未稅加入購物車Quick View -
1.3吋OLED 液晶屏顯示模組 黑底白字 I2C OLED模塊!只需4個引腳
0 滿分 5 分OLED模组4個引腳排列順序有(GND VCC SCL SDA) / (VCC GND SCL SDA)兩種,隨機出貨若有要指定請下單時備註引腳順序。
NT$286NT$171 未稅加入購物車Quick View -
Grove – I2C Touch Sensor 電容式觸摸感測器 I2C 觸摸開關感應器 seeed原廠
0 滿分 5 分I2C 觸摸感測器使用飛思卡爾MPR121晶片,它可以感應觸碰和人的手指的接近。這個感應器包括兩部分——一個觸碰感應控制器和4個感應片。把感應片插到控制器上,就可以開始使用了。
NT$819NT$400 未稅加入購物車Quick View -
Grove – Gas Sensor(MQ5) 氣體感測器 Seeed原廠
0 滿分 5 分可檢測液化石油氣,天然氣,城鎮煤氣等。基於其快速響應時間,測量可以盡快進行。且其靈敏度也可以通過電位器來進行調節。
NT$276NT$220 未稅加入購物車Quick View -
Fan HAT 樹莓派風扇擴展板 I2C控制轉速 PCA9685控制器 液晶顯示即時溫度 專為樹莓派設計
0 滿分 5 分出貨不含樹莓派開發板
NT$857NT$760 未稅加入購物車Quick View -
Grove – 3-Axis Digital Gyro 三軸電子陀螺儀 (I2C) ITG 3200 seeed原廠
0 滿分 5 分電子輸出的三軸MEMS運動處理陀螺儀。適用於遊戲、3D鼠標或其他運動檢測相關的應用。
NT$952NT$620 未稅加入購物車Quick View -
GY-SHT31-D 數位型 i2c 通訊 , 溫濕度感測器模組
0 滿分 5 分GY-SHT31-D 數位型 i2c 通訊 , 溫濕度感測器模組
Sensiron Temperature/Humidity sensors are some of the finest & highest-accuracy devices you can get. And, finally we have some that have a true I2C interface for easy reading. The SHT31-D sensor has an excellent ±2% relative humidity and ±0.3°C accuracy for most uses.
NT$410NT$305 未稅加入購物車Quick View -
加入購物車Quick View
Grove – 0.96″ OLED 顯示模組 (SSD1315) 黑底白字 seeed原廠
0 滿分 5 分加入購物車Quick View -
Fermion:LWLP5000 差壓感測器±500pa DFRobot原廠
0 滿分 5 分NT$1,524NT$1,420 未稅加入購物車Quick View -
Adafruit FT232H Breakout 模組 – General Purpose USB to GPIO+SPI+I2C
0 滿分 5 分Adafruit FT232H Breakout 模組 – General Purpose USB to GPIO+SPI+I2C
有想像過在你的電腦或筆電上面銜接一些電子模組嗎?現在你可以透過 Adafruit FT232H Breakout 輕易的達到你要的效果。支援 GPIO + SPI + I2C 的 Arduino 或樹莓派模組。您可以在 Windows 或 Mac 上透過本模組銜接這些常見的設備。並且可以簡單的透過 python 或者 c 來鑽寫控制這些設備
FT232H芯片能做什麼?來自FTDI的這款芯片 類似於其USB轉串行轉換器芯片,但增加了一個“多協議同步串行引擎”,可以使用諸如SPI,I2C,串行UART,JTAG等常見協議!甚至還有一些數字GPIO引腳,您可以讀寫來執行閃光燈,讀取開關或按鈕等。FT232H的突破就像為您的計算機添加一個用於串行協議的小瑞士軍刀!
NT$667NT$500 未稅加入購物車Quick View