FTDI Basic Breakout – 5V FT232RL晶片 SparkFun原廠
NT$695 NT$500 未稅
尚有庫存
- 商品說明
商品說明
FTDI Basic Breakout – 5V FT232RL晶片 美國 SparkFun 原裝進口
這是 Sparkfun FTDI Basic 的最新版本。我底部使用SMD 6針頭,這使得它更小更緊湊。功能一直保持不變。這是FTDI FT232RL USB串行IC的功能擴展板。該板的引腳排列與FTDI電纜匹配使用官方Arduino和副廠的5V Arduino板。它也可以用於一般串行應用。與該板的主要區別在於它引出DTR引腳,而不是FTDI電纜的RTS引腳。當下載新的草圖時,DTR引腳允許Arduino目標自動復位。這是一個非常好的功能,讓您可以下載草圖,而無需點擊重置按鈕。
標記為BLK和GRN的引腳對應於FTDI電纜上的有色導線。FTDI電纜上的黑線為GND,綠色為CTS。使用這些BLK和GRN引腳將FTDI基板與Arduino目標對齊。該電路板具有TX和RX LED,通過FTDI電纜可以更好地使用。您實際上可以看到LED上的串行流量,以驗證電路板是否正常工作。該板旨在降低Arduino開發成本,並提高易用性(自動重置功能!)。我們的Arduino Pro板和LilyPads使用這種類型的連接器。該板的一個很好的功能是板背面的跳線,允許將板配置為3.3V或5V(電源輸出和IO電平)。該闆卡默認為5V,但如果需要切換到3.3V,則可以切斷默認軌跡並添加焊接跳線。
Document
=========================================================
SparkFun FTDI Basic Breakout – 5V
This is the newest revision of our FTDI Basic. We now use a SMD 6-pin header on the bottom, which makes it smaller and more compact. Functionality has remained the same.
This is a basic breakout board for the FTDI FT232RL USB to serial IC. The pinout of this board matches the FTDI cable to work with official Arduino and cloned 5V Arduino boards. It can also be used for general serial applications. The major difference with this board is that it brings out the DTR pin as opposed to the RTS pin of the FTDI cable. The DTR pin allows an Arduino target to auto-reset when a new Sketch is downloaded. This is a really nice feature to have and allows a sketch to be downloaded without having to hit the reset button. This board will auto reset any Arduino board that has the reset pin brought out to a 6-pin connector.
The pins labeled BLK and GRN correspond to the colored wires on the FTDI cable. The black wire on the FTDI cable is GND, green is CTS. Use these BLK and GRN pins to align the FTDI basic board with your Arduino target.
This board has TX and RX LEDs that make it a bit better to use over the FTDI cable. You can actually see serial traffic on the LEDs to verify if the board is working.
This board was designed to decrease the cost of Arduino development and increase ease of use (the auto-reset feature rocks!). Our Arduino Pro boards and LilyPads use this type of connector.
One of the nice features of this board is a jumper on the back of the board that allows the board to be configured to either 3.3V or 5V (both power output and IO level). This board ship default to 5V, but you can cut the default trace and add a solder jumper if you need to switch to 3.3V.
Documents:
- Schematic
- Eagle Files
- USB to serial UART Boards Hookup Guide
- How to Install FTDI Drivers
- FTDI Drivers
- GitHub (Design Files)
相關商品
-
MCU-arduino CP2102 模組 USB 轉TTL USB轉串口 UART STC下載器
0 滿分 5 分NT$114NT$86 未稅加入購物車Quick View -
感測器37件組 | 入門感測器學習Arduino教學套件/詳細Arduino Sensor 入門教材資料
0 滿分 5 分感測器37件組 | 感測器入門學習Arduino套件 |滿滿 2.4G 1CD 入門教材資料
最佳的感測器入門學習Arduino套件,讓您幾分鐘之內快速上手,不需四處奔波搜尋各種教學資料, 直接給給你最齊全的感測器零件組合與教學課程與範例程式,立刻體驗豐富有趣的Arduino創作世界。這款入門套件收錄了 Arduino 初學者最常應用到的感測器零件,以及介紹這 37 種感測器的使用教學與程式範例。
NT$1,333NT$1,000 未稅加入購物車Quick View -
Relay Shield v3.0 繼電器擴充板支援Arduino單機片 seeed原廠
0 滿分 5 分如果你發現Arduino的小電流限制了你的發揮,那麼Relay Shield將會幫到你。這款Relay Shield簡單易用,它允許你使用簡單的靜態繼電器來控制4路大功率設備(每路上至8Amps,35 Volts)。
每一路都配備有LED指示燈以指示繼電器的當前工作狀態。高性能端子的使用使得Relay Shield的使用更加安全和可靠。對於大功率的Arduino項目或者機器人應用,這款Realy Shield將是理想的選擇。
NT$762NT$620 未稅加入購物車Quick View -
MEGA 感測器擴展板 V2.4 Arduino通用 Xbee 藍芽串口 SD卡座 DFRobot原廠
0 滿分 5 分NT$743NT$560 未稅加入購物車Quick View -
Gravity: Bluno Beetle Shield Beetle BLE 多功能擴展板 DFRobot原廠
0 滿分 5 分只要按照說明,將Bluno Beetle焊接在上面,你就可以直插3pin的傳感器和其他擴展設備。另外,擴展板還具備外接電源接口,可直接外接供電。
NT$333NT$260 未稅加入購物車Quick View -
IIC / I2C 介面 LCD 1602 2004 轉接板
0 滿分 5 分IIC/I2C LCD 1602,2004 轉接板不含 LCD 螢幕
Arduino控制板IO口只有20個,加些傳感器、SD卡啥的,繼電器等模塊多了,IO口就不夠用了,原來的1602屏需要7個IO口才能驅動起來,我們開發的這個模塊可以幫你省5個IO口
產品參數:
- 尺寸:41.5mm(長)*19mm(寬)*15.3mm(高)
- 重量:5g
- PCB顏色:黑色
- 供電電壓:2.5-6V
- 支持I2C協議
- 帶背光電源控制,可以通過跳線帽設置是否連接背光電源。插上跳線帽為連接背光電源,拔掉跳線帽為斷開背光電源
- 對比度可調節,旋轉藍色電位器,順時針增強,逆時針減弱。電位器設計在正面,方便客戶隨時隨地自由調節
- 模塊可級聯,最多可級聯8個。通過短路A0/A1/A2修改設備地址。默認地址為0x27
NT$62NT$40 未稅加入購物車Quick View -
CP2102 多功能串口轉換模組 USB 轉 TTL,RS485,RS232互轉 支援3.3V/5V 切換,支援Win 7/8/10
0 滿分 5 分CP2102 多功能串口轉換模組 USB 轉 TTL,RS485,RS232互轉 支援3.3V/5V 切換
全面支持Win8,Win7,WinXp, Win2K,WinCE,Linux,Mac,系統,32位、64位系統,最新驅動全面支持
出廠時撥碼開關已撥到全ON位置,經過測試能夠適應所有模式
NT$238NT$180 未稅加入購物車Quick View -
加入購物車Quick View
Analog/Digital MUX Breakout-CD74HC4067 數位/類比轉換板 16通道 Sparkfun原廠
0 滿分 5 分加入購物車Quick View -
MCP4725 模組 I2C DAC Breakout 開發板 附排針
0 滿分 5 分MCP4725是具有非易失性存儲器(EEPROM)的單通道12位緩衝電壓輸出DAC。 用戶可將配置寄存器位(2位)和DAC輸入數據(12位)存儲到非易失性EEPROM(14位)存儲器中。通過設置配置寄存器位可以把DAC配置成正常模式或節省功耗的關斷模式。 器件可以使用2線I2C兼容串行接口,且由電壓範圍為2.7V至5.5V的單電源供電。
出貨附排針
NT$179NT$100 未稅加入購物車Quick View -
SAMD21 Mini Breakout SparkFun原廠
0 滿分 5 分NT$810NT$720 未稅加入購物車Quick View