Force Sensitive Resistor – FSR400 Small 電阻式壓力感測器 SparkFun原廠
NT$240 未稅
直徑為0.16“(4 mm)的有源感應區域,Interlink Electronics的FSR會根據傳感區域的壓力而改變其阻力,力越強,電阻越小,當沒有壓力應用於FSR,其電阻將大於1MΩ,全壓施加電阻為2.5kΩ。
尚有庫存
- 商品說明
商品說明
Force Sensitive Resistor – FSR400 Small 電阻式壓力感測器 美國 SparkFun 原裝進口 min:2g
直徑為0.16“(4 mm)的有源感應區域,Interlink Electronics的FSR會根據傳感區域的壓力而改變其阻力,力越強,電阻越小,當沒有壓力應用於FSR,其電阻將大於1MΩ,全壓施加電阻為2.5kΩ。
特徵
- 驅動力低至2克
- 寬力靈敏度範圍0.1N – 10N *總長度:1.75“
- 總寬:0.28“
- 感應面積:0.3“
Documents
=========================================================
Force Sensitive Resistor – Small
Interlink Electronics FSRTM 400 series is part of the single zone Force Sensing ResistorTM family. Force Sensing Resistors, or FSRs, are robust polymer thick film (PTF) devices that exhibit a decrease in resistance with increase in force applied to the surface of the sensor. This force sensitivity is optimized for use in human touch control of electronic devices such as automotive electronics, medical systems, and in industrial and robotics applications. The standard 400 sensor is a round sensor 7.62mm in diameter. Custom sensors can be manufactured in sizes ranging from 5mm to over 600mm. Female connector and short tail versions can also be ordered.
This is a small force sensitive resistor. It has a 0.16″ (4 mm) diameter active sensing area. This FSR from Interlink Electronics will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the resistance. When no pressure is being applied to the FSR, its resistance will be larger than 1MΩ, with full pressure applied the resistance will be 2.5kΩ.
Two pins extend from the bottom of the sensor with 0.1″ pitch making it bread board friendly.
These sensors are simple to set up and great for sensing pressure, but they aren’t incredibly accurate. Use them to sense if it’s being squeezed, but you may not want to use it as a scale.
Dimensions
- Overall length: 1.75″
- Overall width: 0.28″
- Sensing area: 0.3″
Features
- Actuation Force as low as 2 grams
- Wide force sensitivity range 0.1N – 10N
Documents:
- Datasheet (400 FSR)
- FSR Integration Guide
- Bildr Tutorial
相關商品
-
Grove – PIR Motion Sensor 紅外線人體移動探測感測器 seeed原廠
0 滿分 5 分這是一個極易使用的紅外線 PIR人體運動探測感測器。通過這個感測器,你可以使你的作品對運動,例如人類的運動作出互動。只要將其接到Grove – Base Shield上,並且下載程序,當有人走入它的探測範圍時,PIR運動探測傳感器就會在它的SIG腳上輸出一個HIGH信號。
NT$333NT$260 未稅加入購物車Quick View -
FlexiForce 壓力感測器 – 1磅 SparkFun原廠
0 滿分 5 分
NT$781NT$740 未稅加入購物車Quick View -
Fermion:LWLP5000 差壓感測器±500pa DFRobot原廠
0 滿分 5 分NT$1,524NT$1,420 未稅加入購物車Quick View -
Grove – Relay 繼電器模組 ( 峰值電壓能力250V 10安培) 支援 Arduino 與 Raspberry Pi seeed原廠
0 滿分 5 分繼電器是數位電路常用的控制開關元件,可用於控制更高的電壓和電流。設置為高電位時,指示燈會亮,繼電器ON。
NT$143NT$120 未稅加入購物車Quick View -
GY-530 VL53LDK 激光測距感測器 ToF測距 飛行時間測距
0 滿分 5 分鐳射測距智慧感測器,新的智慧感測器基於成功的FlightSense™技術,實現更快、更遠、更精確的測距功能,大幅提升手機和平板電腦的拍照性能,為智慧型機器人、用戶檢測、無人機、物聯網和穿戴式裝置市場開拓新的應用機會
NT$362NT$190 未稅加入購物車Quick View -
加入購物車Quick View
TXB0104 電壓位準 I/O轉換板 4bit SparkFun原廠
0 滿分 5 分Texas Instruments TXB0104 模組的擴展板。TXB0104是一款具有自動方向感應功能的4位雙向電壓電平轉換器。這個4位非反相轉換器使用兩個獨立的可配置電源軌。A端口旨在跟踪VCCA。VCCA接受1.2V至3.6V的任何電源電壓。B端口用於跟踪VCCB。VCCB接受1.65V至5.5V的任何電源電壓。這允許在1.2V,1.5V,1.8V,2.5V,3.3V和5V電壓節點之間進行通用的低壓雙向轉換。VCCA不應超過VCCB。我們已經打破了這個模塊上的每個引腳,您可以輕鬆訪問A和B端口。
加入購物車Quick View -
電流轉電壓模組 0/4-20mA 轉 0-3.3V、5V、10V 電壓變送器 信號轉換調理
0 滿分 5 分在電路信號傳輸的過程中電壓信號會隨著傳輸距離的增加而變弱,採用電流傳輸可以避免信號的變弱。
本模組用於電流信號傳輸末端,將信號轉換成電壓信號供單片機檢測。
電流輸入支援4-20Ma、0-20mA,電壓輸出支援0-3.3V、0-5V、0-10V
NT$190NT$114 未稅加入購物車Quick View -
5路循跡感測器 五路紅外線尋跡感測器 帶碰撞、距離檢測功能
0 滿分 5 分NT$190NT$152 未稅加入購物車Quick View -
Gravity: Analog Turbidity Sensor 水濁度感測器 水質檢測 養殖環境監測 For Arduino DFRobot原廠
0 滿分 5 分濁度感測器利用光學原理,通過測量溶液中的透光率和散射率來綜合判斷溶液濁度情況,從而達到檢測水質的目的。
NT$648NT$500 未稅加入購物車Quick View -
Grove – I2C Touch Sensor 電容式觸摸感測器 I2C 觸摸開關感應器 seeed原廠
0 滿分 5 分I2C 觸摸感測器使用飛思卡爾MPR121晶片,它可以感應觸碰和人的手指的接近。這個感應器包括兩部分——一個觸碰感應控制器和4個感應片。把感應片插到控制器上,就可以開始使用了。
NT$819NT$400 未稅加入購物車Quick View