Force Sensitive Resistor – FSR400 Small 電阻式壓力感測器 SparkFun原廠
NT$240 未稅
直徑為0.16“(4 mm)的有源感應區域,Interlink Electronics的FSR會根據傳感區域的壓力而改變其阻力,力越強,電阻越小,當沒有壓力應用於FSR,其電阻將大於1MΩ,全壓施加電阻為2.5kΩ。
尚有庫存
- 商品說明
商品說明
Force Sensitive Resistor – FSR400 Small 電阻式壓力感測器 美國 SparkFun 原裝進口 min:2g
直徑為0.16“(4 mm)的有源感應區域,Interlink Electronics的FSR會根據傳感區域的壓力而改變其阻力,力越強,電阻越小,當沒有壓力應用於FSR,其電阻將大於1MΩ,全壓施加電阻為2.5kΩ。
特徵
- 驅動力低至2克
- 寬力靈敏度範圍0.1N – 10N *總長度:1.75“
- 總寬:0.28“
- 感應面積:0.3“
Documents
=========================================================
Force Sensitive Resistor – Small
Interlink Electronics FSRTM 400 series is part of the single zone Force Sensing ResistorTM family. Force Sensing Resistors, or FSRs, are robust polymer thick film (PTF) devices that exhibit a decrease in resistance with increase in force applied to the surface of the sensor. This force sensitivity is optimized for use in human touch control of electronic devices such as automotive electronics, medical systems, and in industrial and robotics applications. The standard 400 sensor is a round sensor 7.62mm in diameter. Custom sensors can be manufactured in sizes ranging from 5mm to over 600mm. Female connector and short tail versions can also be ordered.
This is a small force sensitive resistor. It has a 0.16″ (4 mm) diameter active sensing area. This FSR from Interlink Electronics will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the resistance. When no pressure is being applied to the FSR, its resistance will be larger than 1MΩ, with full pressure applied the resistance will be 2.5kΩ.
Two pins extend from the bottom of the sensor with 0.1″ pitch making it bread board friendly.
These sensors are simple to set up and great for sensing pressure, but they aren’t incredibly accurate. Use them to sense if it’s being squeezed, but you may not want to use it as a scale.
Dimensions
- Overall length: 1.75″
- Overall width: 0.28″
- Sensing area: 0.3″
Features
- Actuation Force as low as 2 grams
- Wide force sensitivity range 0.1N – 10N
Documents:
- Datasheet (400 FSR)
- FSR Integration Guide
- Bildr Tutorial
相關商品
-
加入購物車Quick View
MAX471 電壓檢測 電流檢測模組 電壓感測器 電流感測器
0 滿分 5 分電流檢測採用美國美信公司生產的精密高端電流檢測放大器晶片MAX471
加入購物車Quick View -
Fermion:LWLP5000 差壓感測器±500pa DFRobot原廠
0 滿分 5 分NT$1,524NT$1,420 未稅加入購物車Quick View -
加入購物車Quick View
TXB0104 電壓位準 I/O轉換板 4bit SparkFun原廠
0 滿分 5 分Texas Instruments TXB0104 模組的擴展板。TXB0104是一款具有自動方向感應功能的4位雙向電壓電平轉換器。這個4位非反相轉換器使用兩個獨立的可配置電源軌。A端口旨在跟踪VCCA。VCCA接受1.2V至3.6V的任何電源電壓。B端口用於跟踪VCCB。VCCB接受1.65V至5.5V的任何電源電壓。這允許在1.2V,1.5V,1.8V,2.5V,3.3V和5V電壓節點之間進行通用的低壓雙向轉換。VCCA不應超過VCCB。我們已經打破了這個模塊上的每個引腳,您可以輕鬆訪問A和B端口。
加入購物車Quick View -
Grove – I2C Touch Sensor 電容式觸摸感測器 I2C 觸摸開關感應器 seeed原廠
0 滿分 5 分I2C 觸摸感測器使用飛思卡爾MPR121晶片,它可以感應觸碰和人的手指的接近。這個感應器包括兩部分——一個觸碰感應控制器和4個感應片。把感應片插到控制器上,就可以開始使用了。
NT$819NT$400 未稅加入購物車Quick View -
加入購物車Quick View
HC-05 串口藍牙模組 (帶底板) 主機/從機可設定 / 帶底板,附 Arduino 範例
0 滿分 5 分請勿將電源接到信號腳上,會直接燒壞模組!
藍牙透傳模組只有4個AT指令,分別是測試通訊,改名稱,改串列傳輸速率,改配對密碼,AT指令必須從TXD,RXD信號腳設置,不能通過藍牙通道設置。發送AT指令的設備可以是各種類型的MCU(比如51,avr,pic,msp430,arm等),也可以是電腦通過串口(PC串口接MAX232以後或者USB轉串口)發送。
加入購物車Quick View -
加入購物車Quick View
Gravity: I2C 非接觸式紅外線溫度感測器 MLX90614 for Arduino DFRobot原廠
0 滿分 5 分加入購物車Quick View -
2串 7.4V 聚合物鋰電池組保護板 大電流2串保護板
0 滿分 5 分NT$76NT$57 未稅加入購物車Quick View -
加入購物車Quick View
Grove – Rotary Angle Sensor 旋轉角度電位器模組 seeed原廠
0 滿分 5 分加入購物車Quick View -
Grove – Relay 繼電器模組 ( 峰值電壓能力250V 10安培) 支援 Arduino 與 Raspberry Pi seeed原廠
0 滿分 5 分繼電器是數位電路常用的控制開關元件,可用於控制更高的電壓和電流。設置為高電位時,指示燈會亮,繼電器ON。
NT$143NT$120 未稅加入購物車Quick View -
加入購物車Quick View
Grove – Multichannel Gas Sensor v2 多通道有害氣體感測器 seeed原廠
0 滿分 5 分加入購物車Quick View