Force Sensitive Resistor – FSR400 Small 電阻式壓力感測器 SparkFun原廠
NT$240 未稅
直徑為0.16“(4 mm)的有源感應區域,Interlink Electronics的FSR會根據傳感區域的壓力而改變其阻力,力越強,電阻越小,當沒有壓力應用於FSR,其電阻將大於1MΩ,全壓施加電阻為2.5kΩ。
尚有庫存
- 商品說明
商品說明
Force Sensitive Resistor – FSR400 Small 電阻式壓力感測器 美國 SparkFun 原裝進口 min:2g
直徑為0.16“(4 mm)的有源感應區域,Interlink Electronics的FSR會根據傳感區域的壓力而改變其阻力,力越強,電阻越小,當沒有壓力應用於FSR,其電阻將大於1MΩ,全壓施加電阻為2.5kΩ。
特徵
- 驅動力低至2克
- 寬力靈敏度範圍0.1N – 10N *總長度:1.75“
- 總寬:0.28“
- 感應面積:0.3“
Documents
=========================================================
Force Sensitive Resistor – Small
Interlink Electronics FSRTM 400 series is part of the single zone Force Sensing ResistorTM family. Force Sensing Resistors, or FSRs, are robust polymer thick film (PTF) devices that exhibit a decrease in resistance with increase in force applied to the surface of the sensor. This force sensitivity is optimized for use in human touch control of electronic devices such as automotive electronics, medical systems, and in industrial and robotics applications. The standard 400 sensor is a round sensor 7.62mm in diameter. Custom sensors can be manufactured in sizes ranging from 5mm to over 600mm. Female connector and short tail versions can also be ordered.
This is a small force sensitive resistor. It has a 0.16″ (4 mm) diameter active sensing area. This FSR from Interlink Electronics will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the resistance. When no pressure is being applied to the FSR, its resistance will be larger than 1MΩ, with full pressure applied the resistance will be 2.5kΩ.
Two pins extend from the bottom of the sensor with 0.1″ pitch making it bread board friendly.
These sensors are simple to set up and great for sensing pressure, but they aren’t incredibly accurate. Use them to sense if it’s being squeezed, but you may not want to use it as a scale.
Dimensions
- Overall length: 1.75″
- Overall width: 0.28″
- Sensing area: 0.3″
Features
- Actuation Force as low as 2 grams
- Wide force sensitivity range 0.1N – 10N
Documents:
- Datasheet (400 FSR)
- FSR Integration Guide
- Bildr Tutorial
相關商品
-
加入購物車Quick View
Gravity: I2C 非接觸式紅外線溫度感測器 MLX90614 for Arduino DFRobot原廠
0 滿分 5 分加入購物車Quick View -
加入購物車Quick View
2路電平轉換模組帶隔離 2-Channel Level Converter (12V to 5V) DFRobot原廠
0 滿分 5 分加入購物車Quick View -
FlexiForce 壓力感測器 – 1磅 SparkFun原廠
0 滿分 5 分
NT$781NT$740 未稅加入購物車Quick View -
Gravity: Heart Rate Monitor Sensor 超小型心率 血氧飽和值 監測傳感器/感測器 DFRobot原廠
0 滿分 5 分DFRobot心率傳感器是一款拇指大小的心率監測儀,專為Arduino微控制器設計。
NT$810NT$700 未稅加入購物車Quick View -
Grove – Air quality sensor v1.3 空氣品質感測器模組 seeed原廠
0 滿分 5 分主要可以監測的氣體是一氧化碳,醇,丙酮,稀釋劑,甲醛等輕微毒性氣體。本模組兼容 5V和3.3V電源。
NT$457NT$300 未稅加入購物車Quick View -
加入購物車Quick View
單片機TTL轉RS485模組 485轉串口UART電平互轉 硬體自動控制流向
0 滿分 5 分加入購物車Quick View -
2串 7.4V 聚合物鋰電池組保護板 大電流2串保護板
0 滿分 5 分NT$76NT$57 未稅加入購物車Quick View -
加入購物車Quick View
HC-05 串口藍牙模組 (帶底板) 主機/從機可設定 / 帶底板,附 Arduino 範例
0 滿分 5 分請勿將電源接到信號腳上,會直接燒壞模組!
藍牙透傳模組只有4個AT指令,分別是測試通訊,改名稱,改串列傳輸速率,改配對密碼,AT指令必須從TXD,RXD信號腳設置,不能通過藍牙通道設置。發送AT指令的設備可以是各種類型的MCU(比如51,avr,pic,msp430,arm等),也可以是電腦通過串口(PC串口接MAX232以後或者USB轉串口)發送。
加入購物車Quick View -
高感度麥克風感測器模組
0 滿分 5 分NT$62NT$38 未稅加入購物車Quick View -
Grove – RTC 高精度時間模組 seeed原廠
0 滿分 5 分支持I2C協議的時鐘芯片DS1307。它使用鋰電池(CR1225)。時鐘/日曆提供秒,分,小時,日,日,月和年信息。
NT$271NT$220 未稅加入購物車Quick View