Force Sensitive Resistor 0.5″ 10kg 壓力感測器 SparkFun原廠
NT$305 NT$220 未稅
這是一個直徑0.5“圓形感應區域的力敏電阻,該FSR將根據施加到感應區域的壓力而改變其阻值,力越大,阻力越低。
尚有庫存
- 商品說明
商品說明
Force Sensitive Resistor 0.5″ 10kg 壓力感測器
這是一個直徑0.5“圓形感應區域的力敏電阻,該FSR將根據施加到感應區域的壓力而改變其阻值,力越大,阻力越低。
應用于FSR時,其電阻值將大於1MΩ,該FSR可感應範圍在100g-10kg範圍內的施加力。
兩個銷從感測器底部延伸出來,間距為0.1英寸,可直接插入麵包板。傳感區域的另一側有一個剝離並粘住的橡膠襯墊,用於安裝FSR。
商品規格
- 總長:2.375“
- 總寬度:0.75“
- 傳感直徑:0.5“
Documents
=========================================================
Force Sensitive Resistor 0.5″
This is a force sensitive resistor with a round, 0.5″ diameter, sensing area. This FSR will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the resistance. When no pressure is being applied to the FSR its resistance will be larger than 1MΩ. This FSR can sense applied force anywhere in the range of 100g-10kg.
Two pins extend from the bottom of the sensor with 0.1″ pitch making it bread board friendly. There is a peel-and-stick rubber backing on the other side of the sensing area to mount the FSR.
These sensors are simple to set up and great for sensing pressure, but they aren’t incredibly accurate. Use them to sense if it’s being squeezed, but you may not want to use it as a scale.
Note: As it states in the Integration Guide, do NOT solder directly to the exposed silver traces. With flexible substrates, the solder joint will not hold and the substrate can easily melt and distort during the soldering. We recommend using a male or female clincher connector instead.
Features
- Overall length: 2.375″
- Overall width: 0.75″
- Sensing diameter: 0.5″
相關商品
-
Fermion:LWLP5000 差壓感測器±500pa DFRobot原廠
0 滿分 5 分NT$1,524NT$1,420 未稅加入購物車Quick View -
加入購物車Quick View
TXB0104 電壓位準 I/O轉換板 4bit SparkFun原廠
0 滿分 5 分Texas Instruments TXB0104 模組的擴展板。TXB0104是一款具有自動方向感應功能的4位雙向電壓電平轉換器。這個4位非反相轉換器使用兩個獨立的可配置電源軌。A端口旨在跟踪VCCA。VCCA接受1.2V至3.6V的任何電源電壓。B端口用於跟踪VCCB。VCCB接受1.65V至5.5V的任何電源電壓。這允許在1.2V,1.5V,1.8V,2.5V,3.3V和5V電壓節點之間進行通用的低壓雙向轉換。VCCA不應超過VCCB。我們已經打破了這個模塊上的每個引腳,您可以輕鬆訪問A和B端口。
加入購物車Quick View -
5路循跡感測器 五路紅外線尋跡感測器 帶碰撞、距離檢測功能
0 滿分 5 分NT$190NT$152 未稅加入購物車Quick View -
加入購物車Quick View
單片機TTL轉RS485模組 485轉串口UART電平互轉 硬體自動控制流向
0 滿分 5 分加入購物車Quick View -
Analog pH Meter Pro Sensor 模擬檢測 PH值(專業版) 相容Arduino DFRobot原廠
0 滿分 5 分NT$2,667NT$2,460 未稅加入購物車Quick View -
Grove – 3-Axis Analog Accelerometer 3軸加速度計 seeed原廠
0 滿分 5 分ADXL335 是一款小巧,薄型,低功耗,完整的3軸加速度計,具有信號調理電壓輸出。 該產品可測量加速度,最小滿量程範圍為±3 g。
NT$476NT$380 未稅加入購物車Quick View -
Fermion: BMM150 Triple Axis Magnetometer Sensor 三軸數位地磁感測器 DFRobot原廠
0 滿分 5 分NT$286NT$260 未稅加入購物車Quick View -
Grove – PIR Motion Sensor 紅外線人體移動探測感測器 seeed原廠
0 滿分 5 分這是一個極易使用的紅外線 PIR人體運動探測感測器。通過這個感測器,你可以使你的作品對運動,例如人類的運動作出互動。只要將其接到Grove – Base Shield上,並且下載程序,當有人走入它的探測範圍時,PIR運動探測傳感器就會在它的SIG腳上輸出一個HIGH信號。
NT$333NT$260 未稅加入購物車Quick View -
Grove – Gas Sensor(MQ5) 氣體感測器 Seeed原廠
0 滿分 5 分可檢測液化石油氣,天然氣,城鎮煤氣等。基於其快速響應時間,測量可以盡快進行。且其靈敏度也可以通過電位器來進行調節。
NT$276NT$220 未稅加入購物車Quick View -
Grove – Relay 繼電器模組 ( 峰值電壓能力250V 10安培) 支援 Arduino 與 Raspberry Pi seeed原廠
0 滿分 5 分繼電器是數位電路常用的控制開關元件,可用於控制更高的電壓和電流。設置為高電位時,指示燈會亮,繼電器ON。
NT$143NT$120 未稅加入購物車Quick View