Force Sensitive Resistor 0.5″ 10kg 壓力感測器 SparkFun原廠
NT$305 NT$220 未稅
這是一個直徑0.5“圓形感應區域的力敏電阻,該FSR將根據施加到感應區域的壓力而改變其阻值,力越大,阻力越低。
尚有庫存
- 商品說明
商品說明
Force Sensitive Resistor 0.5″ 10kg 壓力感測器
這是一個直徑0.5“圓形感應區域的力敏電阻,該FSR將根據施加到感應區域的壓力而改變其阻值,力越大,阻力越低。
應用于FSR時,其電阻值將大於1MΩ,該FSR可感應範圍在100g-10kg範圍內的施加力。
兩個銷從感測器底部延伸出來,間距為0.1英寸,可直接插入麵包板。傳感區域的另一側有一個剝離並粘住的橡膠襯墊,用於安裝FSR。
商品規格
- 總長:2.375“
- 總寬度:0.75“
- 傳感直徑:0.5“
Documents
=========================================================
Force Sensitive Resistor 0.5″
This is a force sensitive resistor with a round, 0.5″ diameter, sensing area. This FSR will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the resistance. When no pressure is being applied to the FSR its resistance will be larger than 1MΩ. This FSR can sense applied force anywhere in the range of 100g-10kg.
Two pins extend from the bottom of the sensor with 0.1″ pitch making it bread board friendly. There is a peel-and-stick rubber backing on the other side of the sensing area to mount the FSR.
These sensors are simple to set up and great for sensing pressure, but they aren’t incredibly accurate. Use them to sense if it’s being squeezed, but you may not want to use it as a scale.
Note: As it states in the Integration Guide, do NOT solder directly to the exposed silver traces. With flexible substrates, the solder joint will not hold and the substrate can easily melt and distort during the soldering. We recommend using a male or female clincher connector instead.
Features
- Overall length: 2.375″
- Overall width: 0.75″
- Sensing diameter: 0.5″
相關商品
-
加入購物車Quick View
2路電平轉換模組帶隔離 2-Channel Level Converter (12V to 5V) DFRobot原廠
0 滿分 5 分加入購物車Quick View -
Grove – RTC 高精度時間模組 seeed原廠
0 滿分 5 分支持I2C協議的時鐘芯片DS1307。它使用鋰電池(CR1225)。時鐘/日曆提供秒,分,小時,日,日,月和年信息。
NT$271NT$220 未稅加入購物車Quick View -
加入購物車Quick View
Force Sensitive Resistor – FSR400 Small 電阻式壓力感測器 SparkFun原廠
0 滿分 5 分直徑為0.16“(4 mm)的有源感應區域,Interlink Electronics的FSR會根據傳感區域的壓力而改變其阻力,力越強,電阻越小,當沒有壓力應用於FSR,其電阻將大於1MΩ,全壓施加電阻為2.5kΩ。
加入購物車Quick View -
Grove – Relay 繼電器模組 ( 峰值電壓能力250V 10安培) 支援 Arduino 與 Raspberry Pi seeed原廠
0 滿分 5 分繼電器是數位電路常用的控制開關元件,可用於控制更高的電壓和電流。設置為高電位時,指示燈會亮,繼電器ON。
NT$143NT$120 未稅加入購物車Quick View -
TF Mini LiDAR 12m (ToF) 雷射 激光 距離測量傳感器/感測器 DFRobot原廠
0 滿分 5 分TF Mini LiDAR是一款基於飛行時間(ToF)技術的單向激光測距儀。
它由特殊的光學和電子設備組成,集成了適用於室內和室外應用環境的自適應算法。
它具有纖巧的機身和遠距離測量的高性能。
NT$1,600NT$1,420 未稅加入購物車Quick View -
加入購物車Quick View
Grove – Multichannel Gas Sensor v2 多通道有害氣體感測器 seeed原廠
0 滿分 5 分加入購物車Quick View -
加入購物車Quick View
Grove – Rotary Angle Sensor 旋轉角度電位器模組 seeed原廠
0 滿分 5 分加入購物車Quick View -
Analog pH Meter Pro Sensor 模擬檢測 PH值(專業版) 相容Arduino DFRobot原廠
0 滿分 5 分NT$2,667NT$2,460 未稅加入購物車Quick View -
加入購物車Quick View
TXB0104 電壓位準 I/O轉換板 4bit SparkFun原廠
0 滿分 5 分Texas Instruments TXB0104 模組的擴展板。TXB0104是一款具有自動方向感應功能的4位雙向電壓電平轉換器。這個4位非反相轉換器使用兩個獨立的可配置電源軌。A端口旨在跟踪VCCA。VCCA接受1.2V至3.6V的任何電源電壓。B端口用於跟踪VCCB。VCCB接受1.65V至5.5V的任何電源電壓。這允許在1.2V,1.5V,1.8V,2.5V,3.3V和5V電壓節點之間進行通用的低壓雙向轉換。VCCA不應超過VCCB。我們已經打破了這個模塊上的每個引腳,您可以輕鬆訪問A和B端口。
加入購物車Quick View -
加入購物車Quick View
單片機TTL轉RS485模組 485轉串口UART電平互轉 硬體自動控制流向
0 滿分 5 分加入購物車Quick View