Force Sensitive Resistor 0.5″ 10kg 壓力感測器 SparkFun原廠
NT$305 NT$220 未稅
這是一個直徑0.5“圓形感應區域的力敏電阻,該FSR將根據施加到感應區域的壓力而改變其阻值,力越大,阻力越低。
尚有庫存
- 商品說明
商品說明
Force Sensitive Resistor 0.5″ 10kg 壓力感測器
這是一個直徑0.5“圓形感應區域的力敏電阻,該FSR將根據施加到感應區域的壓力而改變其阻值,力越大,阻力越低。
應用于FSR時,其電阻值將大於1MΩ,該FSR可感應範圍在100g-10kg範圍內的施加力。
兩個銷從感測器底部延伸出來,間距為0.1英寸,可直接插入麵包板。傳感區域的另一側有一個剝離並粘住的橡膠襯墊,用於安裝FSR。
商品規格
- 總長:2.375“
- 總寬度:0.75“
- 傳感直徑:0.5“
Documents
=========================================================
Force Sensitive Resistor 0.5″
This is a force sensitive resistor with a round, 0.5″ diameter, sensing area. This FSR will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the resistance. When no pressure is being applied to the FSR its resistance will be larger than 1MΩ. This FSR can sense applied force anywhere in the range of 100g-10kg.
Two pins extend from the bottom of the sensor with 0.1″ pitch making it bread board friendly. There is a peel-and-stick rubber backing on the other side of the sensing area to mount the FSR.
These sensors are simple to set up and great for sensing pressure, but they aren’t incredibly accurate. Use them to sense if it’s being squeezed, but you may not want to use it as a scale.
Note: As it states in the Integration Guide, do NOT solder directly to the exposed silver traces. With flexible substrates, the solder joint will not hold and the substrate can easily melt and distort during the soldering. We recommend using a male or female clincher connector instead.
Features
- Overall length: 2.375″
- Overall width: 0.75″
- Sensing diameter: 0.5″
相關商品
-
加入購物車Quick View
Grove – Multichannel Gas Sensor v2 多通道有害氣體感測器 seeed原廠
0 滿分 5 分加入購物車Quick View -
加入購物車Quick View
MAX471 電壓檢測 電流檢測模組 電壓感測器 電流感測器
0 滿分 5 分電流檢測採用美國美信公司生產的精密高端電流檢測放大器晶片MAX471
加入購物車Quick View -
加入購物車Quick View
Grove – Rotary Angle Sensor 旋轉角度電位器模組 seeed原廠
0 滿分 5 分加入購物車Quick View -
Grove – Alcohol Sensor 酒精感測器 seeed原廠
0 滿分 5 分酒精感測器(傳感器)為酒精專用檢測半導體傳感器。它具有良好的靈敏度和回應速度快的特性,本模組適用用於開發便攜式酒精檢測系統。
NT$286NT$220 未稅加入購物車Quick View -
Grove – Infrared Temperature Sensor 紅外線 溫度感測器模組 seeed原廠
0 滿分 5 分紅外溫度傳感器通過接收物體發出的紅外線來測量其溫度。
NT$457NT$380 未稅加入購物車Quick View -
加入購物車Quick View
HC-05 串口藍牙模組 (帶底板) 主機/從機可設定 / 帶底板,附 Arduino 範例
0 滿分 5 分請勿將電源接到信號腳上,會直接燒壞模組!
藍牙透傳模組只有4個AT指令,分別是測試通訊,改名稱,改串列傳輸速率,改配對密碼,AT指令必須從TXD,RXD信號腳設置,不能通過藍牙通道設置。發送AT指令的設備可以是各種類型的MCU(比如51,avr,pic,msp430,arm等),也可以是電腦通過串口(PC串口接MAX232以後或者USB轉串口)發送。
加入購物車Quick View -
加入購物車Quick View
2路電平轉換模組帶隔離 2-Channel Level Converter (12V to 5V) DFRobot原廠
0 滿分 5 分加入購物車Quick View -
加入購物車Quick View
Gravity: I2C 非接觸式紅外線溫度感測器 MLX90614 for Arduino DFRobot原廠
0 滿分 5 分加入購物車Quick View -
Grove – Relay 繼電器模組 ( 峰值電壓能力250V 10安培) 支援 Arduino 與 Raspberry Pi seeed原廠
0 滿分 5 分繼電器是數位電路常用的控制開關元件,可用於控制更高的電壓和電流。設置為高電位時,指示燈會亮,繼電器ON。
NT$143NT$120 未稅加入購物車Quick View -
Grove – PIR Motion Sensor 紅外線人體移動探測感測器 seeed原廠
0 滿分 5 分這是一個極易使用的紅外線 PIR人體運動探測感測器。通過這個感測器,你可以使你的作品對運動,例如人類的運動作出互動。只要將其接到Grove – Base Shield上,並且下載程序,當有人走入它的探測範圍時,PIR運動探測傳感器就會在它的SIG腳上輸出一個HIGH信號。
NT$333NT$260 未稅加入購物車Quick View